Tile, Shingle and Foam Roofing in Youngtown, With Daily Cleanup Built In
We repair, replace and install tile, shingle, foam and flat roofs for homeowners in Youngtown, Sun City and El Mirage. Before work starts we cover plants, protect the driveway and mask what overspray could reach. Before we leave each day, the yard is swept, the nails are pulled up with a magnet and the debris is hauled off.
- 30-year manufacturer material warranty
- Yard covered before work
- Magnet sweep every evening
- Line-item written estimates
Where We Work
We are based in Youngtown, AZ, and handle roofing for homeowners across the surrounding West Valley. That includes Sun City, Sun City West, El Mirage, Surprise and Peoria, along with Glendale, Tolleson, Litchfield Park and Citrus Park.
- Youngtown
- El Mirage
- Sun City
- Glendale
- Sun City West
- Tolleson
- Litchfield Park
- Citrus Park
- Peoria
- Surprise
If your home is close to these towns but not listed, ask when you reach us. The Service Areas page lists the towns we cover.
Roofing Services for Your Home
We work on the roof types found across the West Valley: concrete and clay tile, asphalt shingle, spray foam and other low-slope flat systems. That covers roof repair for a single failed section, full roof replacement and new roof installation down to the deck. Materials we install come with a 30-year manufacturer warranty through roofing material providers. Each service page explains how that roof fails, how we fix it and what moves the price.
Tile Roofing
Clay and concrete tile roofs, including lift-and-relay underlayment work, broken tile replacement and new tile installs, with your yard protected and cleaned daily.
Shingle Roofing
Asphalt shingle tear-off and installation with new underlayment, flashing and ventilation, plus magnet sweeps and cleanup at the end of every work day.
Foam Roofing
Spray polyurethane foam and elastomeric coatings for flat and low-slope roofs, applied with your walls, windows and vehicles masked off.
Roof Replacement
A full tear-off to the deck, new underlayment and flashing, and a property that is swept and cleared every evening until your new roof is finished.
Roof Repair
Targeted fixes for leaks, broken tile, failed flashing and worn foam, traced to the cause and finished with a clean yard.
New Roof Installation
Complete roof systems for additions, garages, casitas and rebuilt homes, built from deck to ridge with the site cleaned every evening.
Flat Roofing
Modified bitumen, TPO and coating systems for flat and low-slope roofs, with tight parapet flashing, clear drainage and a clean yard at the end of each day.
How We Work on Your Property
A roof job is loud and messy for a few days. We plan for that up front so your home and yard come through it in the same shape they started.
Protection goes down first
Before anyone climbs a ladder, we tarp shrubs and flower beds, cover AC condensers and lay plywood where the dump trailer will sit on your driveway. Windows and patio furniture under the roof edge get covered too.
Cleanup every day, not just at the end
Torn-off felt, broken tile and old shingles go straight into the trailer, not onto the gravel. Each evening we run a rolling magnet over the yard, driveway and decomposed granite, where roofing nails like to hide.
We name the part that failed
A leak usually comes from one place: cracked felt under tile, a lifted pipe flashing, a worn foam coating or a clogged scupper. We tell you which one and why it failed, so you know what you are paying to fix.
Overspray is planned for
Foam and coating work only happens in low wind. We ask you to move cars, then mask nearby walls, windows and equipment so the spray stays on the roof.
Estimates you can read line by line
Your estimate lists tear-off, underlayment, flashing, materials and haul-off as separate lines. If we find rotted decking once the old roof is off, we show you before that work is added.
How a Roof Job Runs, Start to Finish
Most homeowners want to know what each day will look like. This is the order we follow.
- 1
A phone conversation about your roof
Tell us the roof type, its age if you know it and what you are seeing, such as a ceiling stain or loose tile. We set a time to come out and measure.
- 2
Measuring and a written estimate
We measure the roof, check the underlayment, flashing and decking where we can reach them, and note the repair or replacement options. The estimate lists each part of the work separately.
- 3
Setup and protection
On day one we place the trailer, cover plants and equipment, and pull the permit where your town requires one. Tile we plan to reuse is stacked on the roof, not on your lawn.
- 4
The roof work and daily cleanup
We tear off, repair decking, lay underlayment, set flashing and install the new roof surface. Each afternoon the yard is swept and magnet-checked before the crew leaves.
- 5
Final walk and haul-off
We walk the finished roof and the yard with you, remove the last of the debris and the protection, and go over the warranty paperwork.
What Moves the Price of a Roof
Two homes with the same square footage can end up with very different roof prices. The difference is usually in what is under the surface, how the roof is shaped and which system goes back on. Here is what we look at when we put your number together.
We measure the roof, look at its condition and then walk you through a written, line-item estimate. You get your quote by phone first, with the full breakdown to follow.
- Roof size and pitch
- We price by the roofing square, which is 100 square feet. A steeper pitch slows the crew down and adds safety setup, so it costs more per square than a low-slope roof.
- Material choice
- Asphalt shingle, concrete tile, clay tile and spray foam each carry different material and labor costs. Tile is heavy and slow to handle. Foam needs the right spray equipment and a protective coating on top.
- What we find underneath
- Under tile, the felt underlayment often dries out and cracks long before the tiles wear out. Soft or delaminated decking has to be replaced sheet by sheet, and that only shows once the old layers come off.
- Tear-off and haul-off
- Removing one layer of shingles is quicker than stripping two, or cutting out old foam over a flat roof. Tile that can be reused in a lift-and-relay job saves material, but it takes careful handling and stacking.
- Flashing, vents and penetrations
- Every plumbing vent, skylight, chimney, parapet wall and cooler curb needs its own flashing. A roof with many penetrations takes more hours to seal correctly.
- Permits and timing
- A full reroof generally needs a permit, and the fee depends on the town. Work booked ahead of the summer heat and monsoon season is easier to schedule on dates that suit you.
Roofing Questions We Hear Most
Can my roof be repaired, or does it need to be replaced?
It depends on what failed and how much of the roof it affects. A cracked pipe flashing or a few broken tiles is a repair. If the felt under tile has turned brittle across most slopes, or shingles are shedding granules everywhere, patching only buys a short time. We explain which situation you are in and price both options when both make sense.
How do you keep my yard clean during a reroof?
We tarp plants and beds, cover AC units and put plywood under the dump trailer before tear-off begins. Debris goes directly into the trailer. Every evening we sweep and run a magnet over the yard, driveway and gravel so nails do not end up in tires or bare feet.
What warranty comes with your work?
The labor on our roofs carries a 10-year warranty. When the job wraps up, we explain exactly what that coverage includes and hand you the paperwork to keep with your home records.
Why do tile roofs leak if the tiles look fine?
On a tile roof, the tile mostly blocks sun and turns away the bulk of the rain. The real waterproof layer is the felt nailed to the deck below it. Years of desert heat bake that felt until it goes brittle and splits, often near the eaves and in the valleys, and any water that slips past the tile runs straight through. Most of the time we fix it with a lift and relay: the tile comes off and gets stacked, new underlayment and flashing go down, and every unbroken tile is reset.
How long does foam on a flat roof last?
Spray foam holds up well as long as its elastomeric coating is intact. Sunlight breaks down exposed foam, so once the coating wears thin the foam starts to erode and blister. Recoating on schedule keeps the foam underneath protected, and we can tell you how much coating your roof has left.
Do I need to be home while you work?
No, as long as we can reach the yard and the trailer spot. Please move cars out of the driveway and away from the roof edge, and bring pets inside. We give you an update at the end of each day.
Will you pull the permit?
Yes. Full replacements and new installations usually need a permit, and we pull it where your town requires one. We schedule the required inspections and are on site for them.
The Company Behind Your Roof
Youngtown Roofing is a roofing contractor serving homeowners in Youngtown and the West Valley towns around it. Low-slope sections, tile laid over aging felt and foam roofs that are due for a recoat make up much of our work, so those are the roofs we know best.
A reroof brings ladders, a trailer and a crew to your home for several days. We plan around that by counting your yard, plants and driveway as part of the job. The finished roof has to be right, and everything around it should look the way it did on the morning we arrived.
- Warranty
- 30-year manufacturer warranty through roofing material providers
Talk With Us About Your Roof
Tell us what your roof is doing and we will explain the likely cause and the next step. You get your quote by phone, and a written breakdown to keep.